[7] key: Open 2nd home appliance.
[8] key: Close 2nd home appliance.
[9] key: Open mini siren or wireless siren. If need to close siren, press any one of 1/2/3/4 keys.
SMS command: 1234 [1-9] #
■
Home Appliance Control
Home Appliance Switch Pairing
：
Home appliance switch can only accept the alarm unit signal control after
paired.
Pairing method: Refer to household appliance switch manaul, make the appliance into the code-pair state,.
Then enter into the remote control setting, press 5-8 key operating the alarm unit send out on or off signals to the
appliance, paired them is ok.
Signal encryption
：
Encrypted wireless signals,can reduce the home appliance mis-operate frequency that
caused by other signals interference.
Encryption method: Enter into system setting, input 73 + XX (2-bit encryption of data) + #
SMS operation: 888873XX #
(Home appliance control settings have a certain complexity, recommend that users complete purchase
directly from the manufacturer).
■
Connect Wireless Siren (Option Function)
This alarm unit can connect wireless siren, to avoid big sound noise to disturb the owner when the siren install
near the alarm unit and make a alarm.
Pair the Siren : Wireless siren can only accept the alarm unit signal control after paired.
Pairing method: According to the wireless siren manual, make the siren stay the code-pair state,then
continue to press 4 times of set button on the alarm unit, sending "open wireless siren" signal to siren,then to pair
them.
Paired wireless siren, will sound when the alarm unit alarming, and stop to sound when the alarm unit
disarm. (Due to wireless control, there may be some time delay)
Signal Encryption
：
Encrypted wireless signals,can reduce the wireless siren mis-alarm frequency that
caused by other signals interference.
Encryption method: Enter into system setting, input 74 + XX (2-bit encryption of data) + #
SMS operation: 888874XX #
(Wireless siren control settings have a certain complexity, recommend that users complete purchase
directly from the manufacturer).
Remote Control Programming
Dial the number associated to the alarm main unit by phone (mobile phone), and after one ringing cycle, you
can hear a voice prompt “Please enter the password”; enter the password by phone keys (factory default of remote
control password: 8888). If the password are correct, you will hear a long “beep” prompt tone; if it is wrong, you will
hear a prompt “the password is invalid, please enter it again”.
9 Maintenance
12
