![background image](http://html1.mh-extra.com/html/danfoss/vlt-aqua/vlt-aqua_manual_3707178021.webp)
Behavioural Objectives
¾
Identify the drives power connections and control card terminals
¾
Program the necessary drive parameters for basic open loop control
¾
Learn to identify and wire the electrical & I/O connections to the VLT Aqua Drive
¾
Use the drives data readouts to verify that the hardware is working correctly
¾
Upload a working set of parameters to the LCP
Mechanical Setup
Before power up, you need to verify that all of your power wiring is correct in order to avoid
damage to the drive. Position the drive so that you can see the power connections. Take a
minute to answer the following questions. You can
refer to your documentation
if necessary.
Which terminals should the input voltage be connected to?
____ ____ ____
Which terminals should the motor be connected to?
____ ____ ____
Write down the terminal numbers for relay # 1
____ ____ ____
Write down the terminal numbers for relay # 2
____ ____ ____
Stand the demo unit back on its feet and carefully remove the control card terminal cover.
Match up the control card terminal blocks with the correct letter.
*
check the back of the terminal cover
Analog
I/O
_____
Digital
I/O
_____
Serial Communication
_____
Which 2 terminals are the + 24 volt supply?
_________
Which Terminal is the + 10 volt supply?
_________
20
177R0521-VLT_Aqua_Drive_Training_Handout_BODY.indd 20
4/29/15 2:47 PM