3.5.4. Installation on pedestal
The adjustable frequency drive can also be installed on the floor. A dedicated floor stand is de-
signed for that purpose. It can only be used for units produced after week 50, 2004 (serial number
XXXXXG504).
This section describes the installation of a pedestal unit available for the VLT series adjustable
frequency drives frames D1 and D2. This is an 8 in [200 mm] high pedestal that allows these
frames to be floor mounted. The front of the pedestal has openings for input air to the power
components.
The adjustable frequency drive gland plate must be installed to provide adequate cooling air to
the control components of the adjustable frequency drive via the door fan and to maintain the IP
21/NEMA 1 or IP 54/NEMA 12 degrees of enclosure protections.
There is one pedestal that fits both frames D1 and D2.
Required Tools:
•
Socket wrench with 7-17 mm sockets
•
T30 Torx Driver
Torques:
•
M6 - 4.0 Nm (35 in-lbs)
•
M8 - 9.8 Nm (85 in-lbs)
•
M10 - 19.6 Nm (170 in-lbs)
Kit Contents:
•
Pedestal parts
•
Instruction Manual
3.60: Drive on pedestal.
3. How to Install
VLT
®
HVAC DRIVE High Power
Instruction Manual
46
MG.11.F1.22 - VLT
®
is a registered Danfoss trademark.
3
Содержание FC 100 Series
Страница 131: ...7 Annexes VLT HVAC DRIVE High Power Instruction Manual 7 Annexes MG 11 F1 22 VLT is a registered Danfoss trademark 131 7...
Страница 133: ...VLT HVAC DRIVE High Power Instruction Manual 7 Annexes MG 11 F1 22 VLT is a registered Danfoss trademark 133 7...
Страница 134: ...7 Annexes VLT HVAC DRIVE High Power Instruction Manual 134 MG 11 F1 22 VLT is a registered Danfoss trademark 7...
Страница 135: ...VLT HVAC DRIVE High Power Instruction Manual 7 Annexes MG 11 F1 22 VLT is a registered Danfoss trademark 135 7...