Danfoss ET5025, Руководство оператора

Страница: 46 / 92

4. Rotate anti-clockwise and remove the crimping dies (2) from the
deposit.
5. Check the retaining bolts (3) of the crimping dies for damage.
6. Hold the quick die change system with crimping dies in the cen-
tre of the crimping tool.
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the dies.
•
Take care that no parts of your body are inside the forming
area when the crimping dies close.
ATTENTION!
Risk of damage to machinery!
The retaining bolts and the crimping dies will be destroyed if the
retaining bolts do not fit in the mounting hole of the base dies or
intermediate dies.
•
Pay attention to the correct position of the quick die change
system with crimping dies.
7. Press the button to close the tool.
All retaining bolts (3) must slide into the relevant mounting hole
(4) of the basic or intermediate dies, and the spring-mounted
pressure pieces must engage into the retaining bolts.
8. Remove the quick die change system (1) and check that the
crimping dies fit tightly.
9. Proceed in reverse order to remove the crimping dies.
Always use a complete set of equal crimping dies with the same
identification and diameter. One set comprises eight crimping dies
or seven crimping dies and one matching marking die.