Danfoss ET5025, Руководство оператора

Страница: 53 / 92

Maintenance item
W
ee
kl
y
M
on
th
ly
E
ve
ry
6
m
on
th
s
N
um
be
r
of
ye
ar
s
Hydraulic system
Hydraulic energy lines – hoses: Check for porosity
and leaks.
X
Hydraulic energy lines - bolted connections of hoses
and pipes: Check for leaks.
X
Hydraulic oil: Check oil level, add oil if required (see
“Replacing hydraulic oil” in Section 6).
Hydraulic oil filter: Change according to control dis-
play.
Hydraulic oil: Replace 1
Hydraulic hoses: Have replaced (DIN 20066) no later
than six years after manufacture (see label).
Make sure that replacement hoses are of equivalent
quality (high-pressure hoses).
6
Crimping tool
Crimping tool: Check for damage and wear. X
Retaining bolt: Check for damage. X
Slide bearing plates: Check for wear (see
“Checking and replacing slide bearing plates” in Sec-
tion 6).
X
Pressure springs between base dies: Check for da-
mage.
X
Guiding plates: Check for wear (visible grooves, une-
venness).
X
Hexagon socket screws in the base dies: retighten
after 1,000 crimping cycles for the first time; subse-
quently retighten after 50,000 crimping cycles, each
(HM 2xx M5, tightening torque MA = 8 Nm).
1
Check all bolted connections for secure fitting and
retighten if necessary.
1
Complete crimping tool: overhaul after 150,000 crim-
ping cycles.
Only in case of extreme loads when insulators, struc-
tural steel as well as steel ropes (PFC applications)
are pressure-joined.
1.5