DIS-2/M StreamerPro HDD Large UTP
55
Dallmeier electronic
11.2
Sending the configuration file
The configuration file saved on the configuration PC can be sent to an individual module.
This allows the configuration to be restored on the module that is currently connected.
In addition the configuration file can also be sent to several modules at the same time. This
is a very effective method of configuring several modules identically in terms of certain
configuration groups.
11.2.1
Individual module
To restore the configuration of an individual module, first establish a connection to this
module
¾
Open the Config File Management dialog
using menu points Config File > Send.
¾
Click on Search (Durchsuchen).
¾
Select the relevant configuration file on your
configuration PC.
¾
Click OK.
At the end of the transfer the system will display a list
of transferred (or skipped) configuration groups.
11.2.2
Several modules
The prerequisite for this method is that all the relevant devices are integrated in a LAN (with
suitable cabling and a separate IP address for each device). In addition the password must
be identical for all the devices.
Before the configuration file is sent, it must be saved as described above. However, the
Network settings configuration group must not be included in the file that you save.
If these settings were included, the same IP address would be sent to all the modules.
Since, however, every IP address in the LAN must be unique, this would cause massive
problems in the LAN.
Fig. 11-2
Fig. 11-3
