DIS-2/M StreamerPro HDD Large UTP
25
Dallmeier electronic
8.8
Relays
If the module has a Contact IN / OUT interface, you can configure the Contact OUT relays
via the user interface.
¾
Click on Common settings > Relays ....
¾
Select the appropriate relay.
The Relay x dialog will be displayed.
In Function you can first decide after what events the relay should switch:
z
Error (camera or hard disk failure, check the appropriate checkboxes)
z
Motion (the motion comparison function has identified a changein the image)
z
Camera contact (a control input on Contact IN has switched)
You can also decide the holding time of the relay, in other words how long the relay should
be switched.
¾
To do this, set the Timer to On and enter the holding time in Time (sec.).
In Type, finally, you can decide whether the relay should act as an opener (normally closed)
or a closer (normally open).
¾
Finally save the settings by clicking on OK.
Fig. 8-14
