DIS-2/M StreamerPro HDD Large UTP
30
Dallmeier electronic
9.2
Alarm host
If you wish to configure an alarm host, the module can send alarm messages via the LAN.
A software package (for example PGuard) to evaluate the messages must be running on
the receiving computer.
¾
Select Common settings > Alarm hosts ....
If you have not previously configured an alarm host, only the New option will be displayed.
9.2.1
Setting up
¾
Click on the New ... selection.
The selection is expanded to include the Alarm host 1 entry.
¾
Click on alarm host 1.
¾
Click on Settings.
¾
Click on the Name field.
¾
Enter the name of the computer which is to receive
the alarm notifications.
¾
Click on the IP address field and enter the IP address
of the receiving computer (alarm host).
All the settings for the selected host are only applied
when the checkbox located next to active is checked.
Selecting messages
To select the messages to be sent to the alarm host, open the Messages tab.
¾
Click on Messages.
The following messages can be transmitted:
z
contact rec.
Recording start via contact
z
contact rec. stop
Recording stop via contact
z
motion detection
Recording start for event
z
contact status
Status change of a contact
z
Sedor status
Message from an external sedor device
z
no videosignal
Camera failure, problematic line or similar
z
hard disk failure
Defective hard disk
Fig. 9-2
Fig. 9-3:
Section from Alarm hosts
dialog
Fig. 9-4:
Section from Alarm hosts
dialog