DIS-2/M StreamerPro HDD Large UTP
41
Dallmeier electronic
Deinterlacing
If this function is active, the fields supplied by the camera will be edited. In this case the so-
called comb effect, which may occur after merging two fields into a frame, is calculated
from the frame. There are three different processing methods available for this purpose
(automatic, overlay and motion).
NOTE
Deinterlacing is only possible with a resolution of HalfD1 or
over.
The aim of this function is to increase the image quality. However, whether this aim is
achieved depends on a large number of influences. These influences include, for example,
the speed of the motions in the image and also on the type of the output device on the
decoder side (digital or analog monitor).
It is therefore not possible to provide a general recommendation to activate or deactivate
this function. We recommend that you test the output on the decoder after the module has
been configured.
For this purpose, select a typical scene for playback for the camera concerned. If the comb
effect can be detected when objects move, in other words if a lack of focus occurs, the
effect can be reduced by activating Deinterlacing. On the other hand the playback may be
very focused but jumpy. In this case the deactivation of this function may, in certain
circumstances, result in more flowing playback.
10.2
Track
The number of tracks depends on the number of the module’s hard disk drives. A module
with two hard disk drives can be configured with one track on 2 HDD or with two tracks
each on one HDD.
NOTE
In standard configuration one track on all available HDDs is
defined.
An existing allocation of a track to a hard disk drive always can be deleted and redefined.
But in this case all recordings will be lost.
10.2.1
Creating tracks
¾
Click on Tracks … > New.
Fig. 10-2