DIS-1/S
26
Dallmeier electronic
9.2.2
Time control
The calendar function for the alarm host can be used to limit notification transmission to
certain time periods.
NOTE
Please note that this
„
calendar“ only applies to the selected
alarm host.
Additionally, there is no connection to the calendar function for
video recording.
9.2.2.1
Set week schedule
¾
Click in the selection list on the host for which
you would like to configure the calendar
¾
Click on the Scheduler button.
All areas in the weekly plan which are shown as
light colored are active areas (pre-set). This
means that within this time area all selected
messages will be sent to the corresponding alarm
host.
¾
Click on the not active button.
¾
While you are in the weekly plan click once with the right mouse
button.
The area will now appear dark. Dark areas are inactive time areas.
The smallest time unit you can set is 15 minutes.
In the example shown here the time from 01:15 to 01:30 has been
marked as not active. This means that within this time period no
messages will be forwarded to the alarm host.
¾
To undo the marking click on the active button and trace a square over the inactive area.
You also can remark certain sections within the inactive area as active by tracing the particular
section.
Active and inactive time areas defined using the above-mentioned method are valid for the
entire year.
¾
If no exceptions are to be made (see chapter Exceptions to the weekly plan) click on
OK.
Fig. 9-6
Fig. 9-7
Fig. 9-8