Daktronics ST-3170, Руководство пользователя, Страница: 22 / 50

Mechanical Installation
18
5� Using the provided 5/16" T-handle hex wrench, latch both latches on the left table
to the right table (as viewed from the rear). The wrench must be rotated 285° or a
little over a 3/4 turn to fully engage the latch. Refer to Figure 33 for the location of
these latches and proper T-handle wrench rotation. If it is difficult to turn the T-handle
wrench, verify tables are pushed tightly together and aligned front-back.
Figure 33: Latch Locations and T-Handle Wrench
6� Repeat Steps 2–5 for all remaining tables. Store the T-handle hex wrench in a
convenient location, such as inside the cable tray.
Note: Be sure to unlatch all tables from each other before performing the steps in Table
Teardown – Stationary to Transport Mode (p�14) .
Attach End Pads
To keep players safe and protect the table from damage, end pads must be attached
any time the table is in use during games and events.
The left- and right-side end pads are identical in shape and attach in the same manner.
Each pad is marked with an “L” or an “R” to indicate which side of the table it will attach
to (as viewed from the front). The example shown in Figure 34 is a right-side pad, but left-
side pads will attach the same way.
To attach the end pads, follow these steps:
1� Position the end pad at the end of the section. Four bolts attached to each end pad
align with keyhole cutouts in the table frame.
2� Lift the pad up so all four bolts may be inserted into the keyhole cutouts. It is critical
that all four bolts are positioned properly so they hold the pad securely onto the end
of the table.
3� Slide the pad downward in the side of the frame after all four bolts are properly
positioned in the keyhole cutouts. This secures the end pad onto the table.