Daktronics DAKT-0204-02, Руководство пользователя

Страница: 43 / 63

Installing and Configuring a DataProbe iBoot G2 for
Street Furniture
DD2594516 Rev 1
31 July 2013
PO Box 5128 201 Daktronics Drive, Brookings, SD 57006-5128
tel: 800-325-8766 fax: 605-697-4700
www.daktronics.com
Power Connections
Connect the device to be powered ON and Off to the IEC receptacle market A/C Outlet, An IEC 320 to d.
If a cord with a different terminating receptacle is required, be sure it is properly rated and meets all the
required local electrical standards. If the device to be powered uses an IEC320 receptacle and detachable
power cord, an IEC to IEC extension cord can be used.
Make sure that the combined load of all controlled devices down not exceed 12 Amps for 105-125VAC or
10 Amps for 210-240VAC.
An LED Indicator next to the Switched Outlet will be On to indicate that the power is On at that outlet.
This LED will turn Off to indicate that the power is Off to the outlet.
Connect the supplied power cord to the connector labeled AC Input, and the other end to your AC
source. If a power cord with a different terminating plug is required, be sure it is properly rated and
meets all the required local electrical standards.
Expansion Connections
iBoot-G2+ has two Expansion Ports, Exp1 and Exp2 for connection to iBoot-Exp, or for use as General
Purpose Inputs and Outputs (GPIO). Mode settings on the iBoot-G2+ determine how the expansion ports
function.
Connections to the iBoot-Exp are made using screw terminal blocks. The screw terminal blocks are on
removable connectors for easy cable fabrication.
Make sure screw terminals are tightened securely and that there are no loose strands of cable, or excessive
stripped wires. Ensure the cable jacket is not being crimped.
Connecting to iBoot-Exp
Terminal blocks are connected pin-to-pin with the iBoot-Exp as shown:
Figure 3: Proper and Poor Screw Terminal Connections