IM 1119-1
9
www.DaikinApplied.com
5 .
Using a small regular screwdriver, loosen the set screws
holding the wires to the terminal plug on the touchpad
board (Figure 12).
NOTE:
Remove one wire at a time and reconnect to the
corresponding terminal on the RCN terminal plug. The terminal
plug may be removed from the RCN to avoid excessive
handling of the board while making wire connections.
Figure 12: Remove wires one at a time and reconnect to
corresponding terminals on RCN board terminal plug
Touchpad Control
Board
RCN Board
Terminal Plug
6 .
After making all wire connections, plug the RCN terminal
plug onto the RCN board.
7 .
Apply the provided wireless remote control decal over the
face of the touchpad control (Figure 13).
Figure 13: Apply wireless remote control decal
8 .
Restore power to the unit.
9 .
Introduce the RCN and the wireless temperature control
thermostat to each other, following the procedure for
“Installing Nodes” in OM 897. Instructions can also be
found on the inside of the wireless temperature control
thermostat casing.
