IM 1119-1
17
www.DaikinApplied.com
Step 2
The UP button on the front of the thermostat is used to toggle
between the following two choices:
Install
- Install a Node
Remove
- Uninstall ALL Nodes
(The Remove option will be discussed later.)
Figure 19: Install Setup Display
Press the HEAT/COOL to select install.
Step 3
The node number digits will now flash. Use the UP button to
set the node number you wish to install 0-7. If this is the first
node or only node to be installed to this thermostat, leave the
node number at zero.
Press the HEAT/COOL button to select the node number.
Step 4
The control node can be installed to a thermostat as a HEAT
only, COOL only or HEAT & COOL node. After selecting the
node number, the HEAT and/or COOL icon will flash in the
upper right hand quarter of the display as shown in Figure
19. Press the UP button to scroll through the following three
choices:
Heat
- Install node as a heating only control
Cool
- Install node as a cooling only control
Heat/Cool
- Install node as a heating and cooling control
Press the HEAT/COOL button when the appropriate icon is
displayed.
At this point all selections have been made and nothing on the
display should be blinking. You are now ready to install a node.
Step 5
Press the SW9-LINK button on the back of the thermostat
printed circuit board. Within 5-seconds, activate the link service
request on the remote control node you are installing by the
following method: Apply power to the RCN (apply power to the
unit) or press PB3 if power has been applied to the RCN before
the link request has been initiated from a T9000 wireless
thermostat.
See Figure 20 on page 18
.
