IM 1119-1
11
www.DaikinApplied.com
5 .
Feed the provided RCN wire harness through the knockout
opening and snap the RCN bezel and board assembly into
the knockout (Figure 15).
NOTE:
Feed RCN wire harness into the control box through
the top wire hole.
Figure 15: Feed RCN wire harness through front panel
knockout
MicroTech III
Unit Controller
Snap-in RCN
board and
bezel into
knockout
Feed RCN
wire harness
into the control
box through
the top wire
hole.
6 .
Remove the existing wires from the unit control board
terminal plug (TB2), R, C, W, Y, G2.
7 .
Connect the provided (pre-stripped) RCN wire harness
wires to the unit control board plug on terminals R, C, W, Y
& G2 as shown in Figure 16.
Figure 16: RCN wire harness connections to the MicroTech
III unit controller terminal plug
8 .
Reinstall the front panel/filter rack and filter and restore
power to the unit.
