IM 1119-1
7
www.DaikinApplied.com
11 .
Power must be restored to the unit in order for the RCN to
be linked to the T9000 Wireless Thermostat, or if the RCN
is to be custom programmed.
Notes:
1 .
Refer to "RCN Configuration Table for All WSHP Units" on
page
13
for instructions on how to link the RCN(s) to a
T9000 Wireless Thermostat.
2 .
Refer to
"RCN Configuration Table for All WSHP Units" on
page
13
.
for instructions on how to program the RCN.
12 .
After the RCN has been linked with a T9000 Wireless
Thermostat, and any RCN application-configuration
programming is completed; re-attach the RCN box top (with
bezel, overlay, wire harness & control module) to the unit-
mounted RCN back plate, with the 3 previously removed
screws (2-top/1-bottom) from step 2.
Figure 9: Re-attach the RCN box top to the RCN back-plate
The Remote Control Node allows for a degree of customized
programming by following the "Remote Control Node (RCN)
Application – See "RCN Configuration Table for All WSHP Units"
on page 13. RCN must be configured for application prior to
completion of installation.
NOTICE
