Daikin FTXM09VVJU, Инженерные данные

Страница: 218 / 236

216
FTXM-V Series EDUS042101
IOD-7133
5
3. Install the drain pan heater.
CAUTION
When drilling a hole, be careful not to damage the
soundproofing material and other components on
the back side.
1) For type D models, exchange the pre-mounted mounting plates for 2 of the alternate mounting plates as indi-
cated below:
Remove pre-mounted
moun � ng plates
Install H alternate
moun � ng plates
2) Remove 1 screw from the bottom frame (and 1 screw from the left frame for type D models) so that the plates of
the drain pan heater can be inserted under the heat exchanger with ease.
3) Lift up the heat exchanger, and insert the plates of the drain pan heater under the heat exchanger.
• The ground plate of the drain pan heater should be installed so that, in type A models, it firmly adheres to the
bottom frame and, in type B and C models, it firmly adheres to the partition plate.
• Install the drain pan heater in a position where it does not come into contact with the fan motor base.
4) If there are no holes, drill ɸ1/8 inch (ɸ3.2mm) holes in the bottom frame or the partition plate
(model type dependent) to fix the drain pan heater.
• Place the actual components to ensure positioning is correct before drilling holes.
• The holes can be made with the included piercing-screw as well.
5) Fix the drain pan heater with the piercing screws.
6) Reattach the screw that was removed from the bottom frame (as well as the screw that was removed from the left
frame for type D models).