Instruction
SiENBE12-713
178
System Configuration
Check again
Please check again before calling a repair person.
Case
Check
The air conditioner does not operate.
(OPERATION lamp is off)
• Hasn’t a breaker turned OFF or a fuse blown?
• Isn’t it a power failure?
• Are batteries set in the remote control?
• Is the timer setting correct?
Cooling (Heating) effect is poor.
• Are the air filters clean?
• Is there anything to block the air inlet or the outlet of the indoor and the
outdoor units?
• Is the temperature setting appropriate?
• Are the windows and doors closed?
• Are the air flow rate and the air direction set appropriately?
Operation stops suddenly.
(OPERATION lamp flashes)
• Are the air filters clean?
• Is there anything to block the air inlet or the outlet of the indoor and the
outdoor units? Clean the air filters or take all obstacles away and turn
the breaker OFF. Then turn it ON again and try operating the air
conditioner with the remote control. If the lamp still flashes, call the
service shop where you bought the air conditioner.
• Are operation modes all the same for indoor units connected to outdoor
units in the multi system?
If not, set all indoor units to the same operation mode and confirm that
the lamps flash.
Moreover, when the operation mode is in “AUTO”, set all indoor unit
operation modes to “COOL” or “HEAT” for a moment and check again
that the lamps are normal. If the lamps stop flashing after the above
steps, there is no malfunction.
An abnormal functioning happens during operation.
• The air conditioner may malfunction with lightning or radio waves. Turn
the breaker OFF, turn it ON again and try operating the air conditioner
with the remote control.
Содержание FTKS20D3VMW
