SiENBE12-713
Instruction
System Configuration
197
ATTENTION
Preperation Before Operation
"
To use ON TIMER operation
•
Check that the clock is correct. If not, set the
clock to the present time.(page 8)
1. Press “ON TIMER button”.
•
6:00
is displayed.
•
“ON” blinks.
2. Press “SELECT button” until the time setting
reaches the point you like.
•
Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
3. Press “ON TIMER button” again.
•
The TIMER lamp lights up.
"
To cancel ON TIMER operation
4. Press “CANCEL button”.
•
The TIMER lamp goes off.
"
To combine ON TIMER and OFF TIMER
•
A sample setting for combining the two timers is
shown below.
"
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote control.
1,
3
4
2
(Ex
a
mple)
Com
b
ined
Di
s
pl
a
y
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Содержание FTKS20D3VMW
