Operation methods
46
Setting the operation codes for Groups and Zones
Operation control modes (remote controller disabled, centralized operation prioritized, last operated
prioritized, etc.) can be set according to your requirements.
1
[SETTINGS screen]
2
3
4
To set
1
Tap “Operation Code” in the menu on
the left.
2
Select the target units (a Group, all
Groups, or a Zone) via the relevant view.
•
In the image, Group 000 is selected as an
example.
•
Tapping [
] or [
] at the bottom
scrolls through the list of Groups or Zones.
3
Tap the operation code you want to
apply. (0 to 19)
•
Tapping [
] or [
] at the bottom
scrolls through the list of operation codes.
4
Tap
to apply the setting.
If you want to cancel the change made,
tap
.
5
Repeat steps 2 to 4 until all necessary
settings are complete.
Note:
•
The operation code set last will be applied.
Example:
When setting an operation code of “0” to all
Groups, and then setting an operation code of
“1” to Group 001.
Setting result: Group 001
Operation code 1,
All other Groups
Operation code 0