Operation methods
20
List of operation modes which can be set
There are 2 types of control (A or B) depending on whether the target Group or Zone has a master remote
controller setting.
A: Zones or Groups with no “
” displayed
(The individual Group or some of the Groups in the Zone do not show “
” on the Group monitoring
panel.)
If a Group monitoring panel does not show “
”, this indicates that the Group has a master remote
controller setting.
The master remote controller setting enables cool/heat selection.
Some operation modes other than Cool/Heat can also be set. For details, see the list below.
B: Zones or Groups with “
” displayed
(The individual Group or all the Groups included in the Zone show “
” on the Group monitoring panel.)
If a Group monitoring panel shows “
”, this indicates that the Group does not have a master remote
controller setting.
Cool/Heat selection is not available because a master remote controller has not been set.
Some operation modes other than Cool/Heat can also be set. For details, see the list below.
: Available
: Not available
Display
A
: Zones or Groups with no “
” displayed
Display
B
: Zones or Groups with “
” displayed
Setting
Details
Setting
Details
Can be set in individual Zones or Groups
The displays are shown by Group *4
Can be set in individual Zones or Groups
The displays are shown by Group *4
Can be set in individual Zones or Groups
Can be set in individual Zones or Groups
* 1
Can be set in individual Zones or Groups
To be set by Zone *2
or
or
* 1
Can be set in individual Zones or Groups *3
or
or
* 1
Can be set in individual Zones or Groups *3
* 1
Can be set in individual Zones or Groups
* 1
Can be set in individual Zones or Groups
*1: Setting may not be available depending on the type of indoor unit to which this unit is connected.
*2: Under Zone control, the units run in temperature adjustment mode (heating or cooling) for the outdoor
system for Groups registered to the Zone. Heat/Cool selection is not available.
*3:
or
or
Ventilation mode cannot be changed in Zone view. To change the ventilation mode, use Group view.
*4: Under Group control, the units run in temperature adjustment mode (heating or cooling) for the Group
outdoor system. Heat/Cool selection is not available.
Note:
•
Fan operation can be performed for each Zone using the simple remote controller even without
Cool/Heat selection privilege during cooling or heating.
Additionally, if a Ventiair is connected in a Zone, ventilation operation is possible.
See the included operating manuals for details.
•
The indoor fan stops during defrost/hot start.
•
DRY cannot be set from the simple touch controller.