Daikin Clima-Flex CLIC Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 60 / 118

iom-clic-cf-eng www.clima-flex.com
60
Table 11.
Digital outputs of the MASTER unit
#
DESCRIPTION COLD AIR TYPE DESCRIPTION HOT AIR TYPE SIGNAL TYPE EXPECTED RANGE
NO1 COMPRESSOR stage 1 /
VENTILATOR
COMPRESSOR stage 1 /
VENTILATOR
DRY CONTACT 24VAC
NO6 PUMP PUMP (NOT INCLUDED IN ALL
UNITS)
DRY CONTACT 24VAC
NO8 N/A HEAT VALVE DRY CONTACT N/A
Table 12.
Analog inputs of the SLAVE unit
#
DESCRIPTION COLD AIR TYPE DESCRIPTION HOT AIR TYPE SIGNAL TYPE EXPECTED RANGE
B1 INJECTION TEMPERATURE INJECTION TEMPERATURE NTC r25=10kΩ + 1%
B2 RETURN TEMPERATURE RETURN TEMPERATURE NTC r25=10kΩ + 1%
B3 SUCTION SUCTION NTC r25=10kΩ + 1%
B4 CONDENSER TEMPERATURE CONDENSER TEMPERATURE NTC r25=10kΩ + 1%
Table 13.
Digital inputs of the SLAVE unit
#
DESCRIPTION COLD AIR TYPE DESCRIPTION HOT AIR TYPE SIGNAL TYPE EXPECTED RANGE
DI1 HIGH PRESSURE HIGH PRESSURE DRY CONTACT N/A
DI2 LOW PRESSURE LOW PRESSURE DRY CONTACT N/A
DI3 EVAPORATOR FLOW EVAPORATOR FLOW DRY CONTACT N/A
DI4 PHASE MOTOR PROTECTOR PHASE MOTOR PROTECTOR DRY CONTACT N/A
Table 14.
Digital outputs of SLAVE unit
#
DESCRIPTION COLD AIR TYPE DESCRIPTION HOT AIR TYPE SIGNAL TYPE EXPECTED RANGE
NO1 COMPRESSOR stage 1/
VENTILATOR
COMPRESSOR stage 1/
VENTILATOR
DRY CONTACT 24VAC
NO2 **PUMP **PUMP DRY CONTACT 24VAC
NO3 SECOND STAGE SECOND STAGE DRY CONTACT 24VAC
NO4 RECOVERY RECOVERY DRY CONTACT N/A
Note**: The digital output pump on SLAVE units depends on the initial configuration. It is not possible to use the pump if the
system is configured with only one MASTER pump unit.
Unit Controller Operation
SET POINTS
When we start configuring the unit for the first time all the preload parameters have a default value, these values are stored in permanent
memory but can be changed depending on the application of the unit.
The values can be changed from the display and the submenus require a password if you want to change the values; if an option is not
included in the display menu the data is only an internal value in the controller and will be visible only if that mode is selected.
The table below has a description of each default set point and can be set to any value in the range column.