Daihen OTC Welbee Inverter W400, Руководство пользователя

Страница: 62 / 158

W
IRE
I
NCHING
W
ELDING
O
PERATION
C
HAPTER
5
5-6
5.
Turn the flow rate adjustment knob to "OPEN", and adjust the flow rate of shielding gas.
6.
Press the GAS CHECK key.
⇒
The LED of the GAS CHECK key lights off, to stop gas check.
5.4 Wire Inching
This section explains the inching operation (feeding operation) of the wire.
1.
Straighten the torch cable.
⇒
Bent cable may cause feeding failure of the wire or wire bending.
2.
Press the WIRE INCH key to feed the wire.
●
Keep pressing the WIRE INCH key until the wire protrudes from the end of the tip in approximately
10 mm. Releasing the WIRE INCH key will stop the wire feeding. For excessive wire, cut the wire
using a plier.
⇒
Turning the parameter adjusting knob during the wire feeding can adjust the feed speed.
TIPS
• Wire feeding is also enabled by a remote control (optional). Turning the welding current
adjustment knob can adjust the feed speed. ( 6.8
-
Operation of Analog Remote Control
(Optional))
• Do not look into the tip of the welding torch during the inching operation. Do not bring
the tip of the welding torch to face, eyes, or body.
The wire may abruptly burst out, resulting in an injury.
• Keep hands, fingers, hair and clothes away from the feed roll of the wire feeder.
It may cause an entanglement.
WIRE INCH
Welding power
source
WIRE INCH key
10mm