Dahua Technology IVSS Series, Руководство пользователя

Страница: 49 / 376

User's Manual
29
3.4.1 Alarm Connection
Before using the alarm, connect alarm input or alarm output device.
3.4.1.1 Connection
The section introduces alarm connection of the Device.
Alarm Input
●
Both NO and NC are supported.
●
The alarm input port supports alarm signal from ground and device of 12-24 V voltage.
●
If the alarm device is connected to the Device and other devices, use relay for isolation.
Alarm Output
The alarm output port cannot be connected to high-power load (less than 1A). When forming output
circuit, the excessive current should be prevented from causing damage to the relay. Use the
contactor for isolation when applying high-power loads.
PTZ Decoder Connection
●
The common-ground must be prepared for PTZ decoder and the Device; otherwise the common-
mode voltage might not be able to control the PTZ. It is recommended to use shielded twisted
pair, and the shielding layer can be used for common ground.
●
Prevent interference from high-voltage power, make reasonable wiring, and take measures for
lighting protection.
●
Remotely import 120 Ω to reduce resistance reflection and protect the signal quality.
●
The Device A line and B line cannot connect to other RS-485 output device in parallel.
●
The voltage between the A line and B line of PTZ decoder must be less than 5 V.
Notes to Grounding
●
Poor grounding of camera might damage the chip.
●
When supplying external power source to the alarm device, the alarm device should be
common-grounded with the Device.