D-Link TM DES-6500, Справочное руководство по интерфейсу командной строки

Страница: 120 / 267

config link_aggregation
<port>
−
Master port ID. Specifies which port (by port number) of the
link aggregation group will be the master port. All of the ports in a link
aggregation group will share the port configuration with the master port.
<portlist>
−
Specifies a range of ports that will belong to the link
aggregation group. The DES-6500 will only support aggregated links
where all of the aggregated ports are contained on the same line card
(slot). The port list is specified by listing the slot number of the line card
and the beginning port number on that slot, separated by a colon. Then
the same slot number (because all of the aggregated ports must be on
the same line card), and the highest port number of the range (also
separated by a colon). The beginning and end of the port list range are
seperated by a dash. For example, 1:3 specifies slot number 1, port 3.
1:7 specifies slot number 1, port 7.
state [enabled|disabled]
−
Allows you to enable or disable the specified
link aggregation group.
Restrictions Only administrator-level users can issue this command. Link
aggregation groups may not overlap and must be contained on a single
switch.
Example usage:
To define a load-sharing group of ports, group-id 1, master port 1:5 with group members ports 1:5-1:7 plus port 1:9:
DES-6500:4#config link_aggregation group_id 1 master_port
1:5 ports 1:5-1:7, 1:9
Command: config link_aggregation group_id 1 master_port
1:5 ports 1:5-1:7, 1:9
Success.
DES-6500:4#
config link_aggregation algorithm
Purpose Used to configure the link aggregation algorithm.
Syntax config link_aggregation algorithm
[mac_source|mac_destination|mac_source_dest|
ip_source|ip_destination|ip_source_dest]
Description This command configures to part of the packet examined by the switch when
selecting the egress port for transmitting load-sharing data. This feature is only
available using the address-based load-sharing algorithm.
Parameters
mac_source
−
Indicates that the switch should examine the MAC source
address.
mac_destination
−
Indicates that the switch should examine the MAC
destination address.
mac_source_dest
−
Indicates that the switch should examine the MAC source
and destination addresses