D-Link DXS-3227 - xStack Switch - Stackable, Руководство по установке в сети

Страница: 247 / 424

DXS-3227, DXS-3227P, DXS-3250 and DXS-3250E EWS User Guide
Page 246
Defining Multicast Bridging Groups
The Multicast Group Page displays the ports and LAGs attached to the Multicast service group in the Ports and
LAGs tables. The Ports and LAGs tables also reflect the manner in which the port or LAGs joined the Multicast
group. Ports can be added either to existing groups or to new Multicast service groups. The
Multicast Group Page
permits new Multicast service groups to be created. The Multicast Group Page also assigns ports to a specific
Multicast service address group. To define Multicast groups:
1. Click Advanced Setup > Multicast Support > Bridge Multicast > Multicast Group .The Multicast Group
Page opens:
Figure 169:Multicast Group Page
The Multicast Group Page contains the following information:
•
Enables Bridge Multicast Filtering — Indicate if bridge Multicast filtering is enabled on the device. The pos-
sible field values are:
–
Checked — Enables Multicast filtering on the device.
–
Unchecked — Disables Multicast filtering on the device. If Multicast filtering is disabled, Multicast frames
are flooded to all ports in the relevant VLAN. Disabled is the default value.
•
VLAN ID — Identifies a VLAN and contains information about the Multicast group address.
•
Forwarding Method — The basis for Multicast bridging. Possible field values are:
–
MAC Address Group — Enables Multicast bridging based on the packet’s VLAN and MAC address.
–
IP Address Group — Enables Multicast bridging based on the packet’s VLAN and MAC address for non-
IPv4 packets, and on the packet’s VLAN and IPv4 destination address for IPv4 packets.
–
IP and Source Group — Enables Multicast bridging based on the packet’s VLAN and MAC address for
non-IPv4 packets, and on the packet’s VLAN, IPv4 destination address, and IPv4 source address for
IPv4 packets.