D-Link DXS-3227 - xStack Switch - Stackable, Руководство по установке в сети

Страница: 40 / 424

Initial Configuration
Page 39
3. In the configuration mode, enter the SNMP configuration command with the parameters including community name
(private), community access right (read and write) and IP address, as shown in the following example:
This completes the initial configuration of the device from a local terminal. The configured parameters enable further
device configuration from any remote location.
Advanced Configuration
This section provides information about dynamic allocation of IP addresses and security management based on the
authentication, authorization, and accounting (AAA) mechanism, and includes the following topics:
• Configuring IP Addresses through DHCP
• Configuring IP Addresses through BOOTP
• Security Management and Password Configuration
When configuring/receiving IP addresses through DHCP and BOOTP, the configuration received from these servers
includes the IP address, and may include subnet mask and default gateway.
Retrieving an IP Address From a DHCP Server
When using the DHCP protocol to retrieve an IP address, the device acts as a DHCP client. To retrieve an IP address
from a DHCP server, perform the following steps:
1. Select and connect any port to a DHCP server or to a subnet that has a DHCP server on it, in order to retrieve the
IP address.
2. Enter the following commands to use the selected port for receiving the IP address. In the following example, the
commands are based on the port type used for configuration.
console# configure
console(config)# snmp-server community priate rw 10.1.1.1 view bobi
console(config)# exit
console# show snmp
Community-String Community-Access View name IP address
-------------------- ------------------ -------------- ------------
priate read write bobi 10.1.1.1
private read write bobi 10.1.1.2
Community-String Group name IP address Type
------------------ ------------ ------------------- ------
Traps are enabled.
Authentication-failure trap is enabled.
Version 1,2 notifications
Target Address Type Community Version Udp Filter To Retries
Port name Sec
---------------- -------- ----------- ---------- ----- ------- ----- ---
------
Version 3 notifications
Target Address Type Username Security Udp Filter To Retries
Level Port name Sec
---------------- -------- ----------- -------- ----- ------- ----- -----
----
System Contact:
System Location: