D-Link DXS-1210 Series User Manual
54
Enabled VLAN ID List:
Enter
the VLAN ID for loopback detection. This only takes effect when
VLAN-based
is selected in the
Mode
drop-down list.
Interval (1-32767):
Set a Loop Detection Interval between
1
and
32767
seconds. The default is 2
seconds.
Trap State:
Select
to enable or disable the loopback detection trap state.
Action:
Select
Shut-down
or
None
for loopback detection.
From Port / To Port:
Enter a consecutive group of ports to be configured starting with the selected port.
State:
Use the drop-down menu to toggle between
Enabled
and
Disabled.
Default is
disabled
.
Click the
Apply
button
to save your settings.
L2 Features > Link Aggregation
The Link Aggregation page allows you to view and configure the link aggregation settings.
Figure 4.89 – L2 Features > Link Aggregation
System Priority (1-65535):
Enter
the system’s priority value. This must be between 1 and 65535. By default,
the value is 32768. The system priority determines which ports can join a port-channel and which ports are
put in stand-alone mode. The lower value has a higher priority. If two or more ports have the same priority,
the port number determines the priority.
Load Balance Algorithm:
Specify
the load balancing algorithm that will be used. Options to choose from
are:
Source MAC
,
Destination MAC
,
Source Destination MAC
,
Source IP
,
Destination IP
, and
Source
Destination IP
. By default, this option is
Source MAC
.
System ID:
The
System ID
information.
Click the
Apply
button to save your settings.
Channel Group Information:
From Port / To Port:
Select
the appropriate port range used for the configuration.
Group ID:
Enter
the channel-group number. This value must be between 1 and 32. The system will
automatically create the port-channel when a physical port first joins a channel-group. An interface can only
join one channel-group.
Mode:
Select
either
On
,
Active
, or
Passive
. If you selected
On
, the channel-group type is static. If
Active
or
Passive
is selected, the channel-group type is LACP. A channel-group can only consist of either static
members or LACP members. Once the type of channel-group has been determined, other types of interfaces
cannot join the channel-group.
Click the
Add
button to add a new entry based on the information entered.
Click the
Delete Member Port
button to remove the specific member port.
Click the
Delete Channel
button to remove the specific entry.
Click the
Channel Detail
button to view more detailed information about the channel.
Содержание DXS-1210-10TS
Страница 1: ...User Manual DXS 1210 Series L2 10 Gigabit Ethernet Switch Series Rev A2...
Страница 25: ...D Link DXS 1210 Series User Manual 19 Figure 4 24 User Guide Micro Site...
Страница 134: ......
