D-Link dgs-8000 SERIES, Руководство по установке оборудования, Страница: 62 / 97

DGS-8000 Series Hardware Installation Guide Chapter 4 System Debugging
55
4.1.3
Setting Terminal Parameters
Step 1: Start the PC and run the terminal simulation program on the PC, such as Terminal on
Windows 3.1 or HyperTerminal on Windows 95/98/NT/2000/XP.
Step 2
：
Set terminal parameters. The parameters are as follows: baud rate 9600, data bit 8,
parity check none, stop bit 1, and flow control as none.
4.2
Power-on Startup
4.2.1
Checking before Power-on
 The switch is fully grounded.
 The power cable is correctly connected.
 The power supply voltage complies with the requirement of the switch.
 The console cable is correctly connected; the terminal (can be a PC) used for
configuration is already started; the parameters are already configured.
4.2.2
Checking after Power-on
(Recommended)
After power-on, you are recommended to perform the following checks to ensure the normal
operation of follow-up configurations.
 Check that information is displayed on the terminal interface.
 Check that the device indicator is normal.