D-Link DGS-3312SR, Руководство по эксплуатации продукта

Страница: 82 / 244

DGS-3312SR Gigabit Layer 3 Switch
PVID
A Port VLAN Identifier is a classification mechanism that associates a port with a
specific VLAN and is used to make forwarding decisions for untagged packets
received by the port. For example, if port 2 is assigned a PVID of 3, then all
untagged packets received on port 2 will be assigned to VLAN 3. This number is
generally the same as the VID number assigned to the port in the Edit 802.1Q
VLANs window above.
GVRP
The Group VLAN Registration Protocol (GVRP) enables the port to dynamically
become a member of a VLAN. GVRP is disabled by default.
QoS
QoS settings allow customization of packet priority in order to facilitate delivery of data traffic that might be affected by
latency problems. The IEEE 802.1p Priority specification uses eight priority levels to classify data packets. In 802.1p
compliant devices, a tag inserted into the packet header is used to identify the priority level of data packets.
The Switch implements 802.1p priority using eight hardware queues. Therefore, the Switch must have a means of mapping
the eight levels specified in the IEEE 802.1p standard to the eight hardware queues used in the Switch. This is done using
the Class of Service menu explained below. Further customization of priority classification can be done with the Output
Scheduling menu, also explained below.
Individual ports may still be assigned priority using the eight levels as defined by the 802.1p standard.
It is important to note that changes in a networks QoS scheme should be carefully considered, planned for and if possible
tested for efficiency. When set up properly, it QoS can allow efficient and timely delivery of data for video conferencing or
IP telephony without causing unacceptable delays of other network traffic. If QoS is not well set up however, significant
delays and excessive packet loss may result for data assigned to lower priority queues.
802.1p Default Priority
The Switch allows the assignment of a default 802.1p priority to each port on the Switch.
Click on the 802.1p Default Priority link in the QoS sub-folder:
69