D-Link DGS-3312SR, Руководство по эксплуатации продукта

Страница: 125 / 244

DGS-3312SR Gigabit Layer 3 Switch
and the new redistribution setting appears listed in the table. To eliminate an existing redistribution configuration, click the
X in the Delete column for the configuration being removed.
Refer to the table below for descriptions of the Router Redistribution Settings window settings:
Parameter Description
Dest Protocol Allows the selection of the protocol of the destination device. Available choices are
RIP and OSPF .
Src Protocol Allows the selection of the protocol of the source device. Available choices are RIP ,
OSPF , Static , or Local .
Type Allows the selection of one of two methods for calculating the metric value. Type-1
calculates the metric (for RIP to OSPF) by adding the destination’s interface cost to
the metric entered in the Metric field.
Type-2 uses the metric entered in the Metric
field without change. This field applies only when the destination field is OSPF.
Metric
Allows the entry of an interface cost.
Static/Default Route Settings
Static routes that have been previously configured appear in the Static/Default Route Settings table. To add a new route,
click on the
Add button, a new window appears. To remove an existing route, click the X button in the Delete column for
the route you want to eliminate.
Figure 5- 22. Static/Default Route Settings window
Use the Static/Default Route Settings – Add window to configure IP settings and Metric cost for the new route.
Figure 5- 23. Static/Default Route Settings – Add window
Configure the IP settings for the new static route and click the Apply button to create the static route. The new route will
appear in the previous window. To view the new route and any other static routes configured for the Switch click the Show
All Static/Default Route Entries link.
The following fields can be set:
112