D-Link DGS-3000 series, Справочное руководство

Страница: 189 / 909

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
185
characters long.
ma_index - Specify the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must between 1 and 4294967295.
mepid - Specify the MEP ID used.
<int 1-8191> - Enter the MEP ID used here. This value must be between 1 and 8191.
remote_mepid - Specify the Remote MEP ID used.
<int 1-8191> - Enter the remote MEP ID used here. This value must be between 1 and 8191.
Restrictions
None.
Example
To show the CFM Remote MEP information:
DGS-3000-26TC:admin#show cfm remote_mep mepname mep1 remote_mepid 2
Command: show cfm remote_mep mepname mep1 remote_mepid 2
Remote MEPID : 2
MAC Address : 00-11-22-33-44-02
Status : OK
RDI : Yes
Port State : Blocked
Port Status Defect : Blocked
Interface Status : Down
Interface Status Defect : No
Last CCM Serial Number : 1000
Sender Chassis ID : 00-11-22-33-44-00
Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161
Detect Time : 2008-01-01 12:00:00
DGS-3000-26TC:admin#
show cfm pkt_cnt 16-28
Description
This command is used to show the CFM packet’s RX/TX counters.
Format
show cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) Specify the port counters to show. If not specified, all ports will be shown.
<portlist> - Enter the list of ports used for this configuration here.
rx - (Optional) Specify to display the RX counter.
tx - (Optional) Specify to display the TX counter. If not specified, both of them will be shown.
rx - (Optional) Specify to display the RX counter.
tx - (Optional) Specify to display the TX counter. If not specified, both of them will be shown.