D-Link DGE-560SX User Guide
147
5.
Restart the Remote Installation service. This can be performed from a command line
with the following commands:
net stop binlsvc
net start binlsvc
7.6.3 Linux and ASFIPMon
Problem
: I brought down the interface and now I cannot bring it back up. When I try, the
following message appears, `SIOCSIFFLAGS: Resource temporarily unavailable.'
Solution
: When ASFIPMon is running, it does a quick access to flash ROM every 30 seconds
or so. If the interface is brought down while this is happening, you cannot bring the interface
back up in the usual way. To bring up the interface, unload and then reload the driver module.
7.6.4 Broadcom Boot Agent
Problem
: Unable to obtain network settings through DHCP using PXE.
Solution
: For proper operation make sure that the Spanning Tree Protocol (STP) is disabled
or that portfast mode (for Cisco) is enabled on the port to which the PXE client is connected.
For instance, set spantree portfast 4/12 enable.
7.6.5 Broadcom Advanced Server Program (BASP)
Problem
: The 802.3ad team member links disconnect and reconnect continuously (applies
to all operating systems).
Solution
: This is a third-party issue. It is seen only when configuring an 802.3ad team with
more than 2 members on the system and connecting to an HP2524 switch, with LACP enabled
as passive or active. The HP switch shows an LACP channel being brought up successfully with
only 2 team members. All other team member links disconnect and reconnect. This does not
occur with a Cisco Catalyst 6500.
Problem
: A Generic Trunking (GEC/FEC) 802.3ad-Draft Static type of team may lose some
network connectivity if the driver to a team member is disabled.
Solution
: If a team member supports underlying management software (ASF/IPMI/UMP) or
Wake-On-LAN, the link may be maintained on the switch for the adapter despite its driver
being disabled. This may result in the switch continuing to pass traffic to the attached port
rather than route the traffic to an active team member port. Disconnecting the disabled
adapter from the switch will allow traffic to resume to the other active team members.
