D-Link DGE-560SX User Guide
124
o
To ensure network connectivity to the probe target, ping the probe target
from the team.
o
You can specify up to four probe targets.
o
The IP address assigned to either a probe target or team member cannot
have a zero as the first or last octet.
To configure LiveLink
1.
From the
Teams
menu, select
Edit Team
.
2.
Click Expert Mode (to configure LiveLink using the Teaming Wizard, see Using the
Broadcom Teaming Wizard).
3.
In the Manage Members window, click the
Edit Team
tab.
4.
Select
Enable LiveLink
. The LiveLink Configuration options appear below.
5.
It is recommended to accept the default values for
Probe interval
(the number of
seconds between each retransmission of a link packet to the probe target) and
Probe
maximum retries
(the number of consecutively missed responses from a probe
target before a failover is triggered). To specify different values, click the desired
probe interval in the
Probe interval (seconds)
list and click the desired maximum
number of probe retries in the
Probe maximum retries
list.
6.
Set the
Probe VLAN ID
to correspond with the VLAN where the probe target(s)
resides. This will apply the appropriate VLAN tag to the link packet based on the
shared configuration of the attached switch port(s).
Note: Each LiveLink enabled team can only communicate with Probe Targets on a
single VLAN. Also, VLAN ID 0 is equivalent to an untagged network.
7.
Select
Probe Target 1
and type the target IP address for one or all probe targets.
Note: Only the first probe target is required. You can specify up to 3 additional
probe targets to serve as backups by assigning IP addresses to the other probe
targets.
8.
Select one of the listed team members and type the member IP address.
Note: All of the member IP addresses must be in the same subnet as the probe
targets.
9.
Click
Update
. Repeat these steps for each of the other listed team members.
