D.A.S. M-14:2, Руководство по эксплуатации

Страница: 9 / 27

7
M-14:2
PROFESSIONAL STEREO MIXER
આ Modifications
Mono channel Aux send 2 are post-fader. This modification changes Aux send2 to be pre-fader instead of
post-fader Mono channel.
- Aux send2 : post-fader
ᆎ
pre-fader
If you want to convert them, carry out the modification described below to each mono channel you want to
be altered. See below figure.
1) Power switch off, Remove AC cord.
The work area is on the underside of the PCB board near the channel AUX SEND2 knob.
2) Cut the PCB Line
3) Add a Jumper
8. PAN CONTROL
This control pans the channel signal across the master L and R buses, thus determining the perceived position
of the sound from that channel in the output stereo sound field. If a PAN control is set all the way to the left,
for example, the sound from that channel will be heard from the left speaker system only.
If it is set all the way to the right, the sound will be heard from the right speaker system only.
Intermediate settings will cause the sound to appear at corresponding locations in the stereo sound field.
9. MUTE/ALT 3-4 SWITCH
When the Mute/ALT 3-4 switch is depressed, a channel output will be routed to the ALT 3-4 output instead
of the main mix.
ALT 3-4 bus offers you a second independent stereo submix with its own submaster stereo fader.
10. SOLO SWITCH
When these switch is depressed, the channel input signal can be routed to the solo bus.
This switch allows you to monitor the post-fader channel input signal through headphone outputs and control
room outs.
11. CHANNEL FADER
This is the channels main level control. It determines the level of the signal that is sent from the channel to the
master mixing and effect buses. It is the settings of the input channel faders that determine the mix, or the
balance of sound levels between the instruments or other sources connected to the inputs.
When a channel is not being used, its fader should be set at the minimum position to prevent the addi-tion of
unwanted noise to the main program signal.
AUX2
Before
POST
PRE
Cut the PCB Line
AUX2
After
POST
PRE
Add a Jumper