D.A.S. M-14:2, Руководство по эксплуатации

Страница: 16 / 27

14
M-14:2
PROFESSIONAL STEREO MIXER
2. INPUT/OUTPUT CONNECTORS B
1. POWER SWITCH
This switch turns the power ON/OFF. When in the ON position, the power indicator will light.
2. PHANTOM POWER SWITCH
When is the ON position, +48V DC phantom power will be provided between pin 2 and pin 3 of the XLR-
type jack. If you do not need phantom power, be sure to turn this to the OFF position.
3. ALT 3/4 OUTPUT JACKS
These are unbalanced 1/4" phone type output jacks which output the signals of ALT 3/4 buses with a
nominal output/impedance of +4dB/600
Ω
.
4. AUX SEND 1 ~ 2 JACKS
These are unbalanced 1/4" phone jacks with a nominal output and impedance of +4dB/600
Ω
.
The AUX SEND 1~ 2 output signal is the sum of all of the input channel AUX SEND 1~ 2 buses.
5. AUX RETURN 1~ 2 JACKS
These are unbalanced 1/4" phone jacks with a nominal level and impedance of +4dB/10k
Ω
.
These jacks are usually used to receive the audio returned from an effect unit such as reverb or delay, but
they can also be used as supplementary inputs.
If a plug is inserted only in L/MONO, the same signal will be sent to both the L and R buses.
These allow you to return signal from outboard devices, either in stereo pairs or mono phonically (many
popular effects processors provide a single mono input but have a pair of stereo outputs).
In practice, you'll probably want to use the Auxiliary returns to bring in signal from connected effect
processors. If the effects processors have stereo outputs, they should be connected to both the left and right
Auxiliary return inputs so that their stereo integrity is retained. If they have mono outputs, you can route them
to either the left or right inputs and then use the Auxiliary return Balance control to adjust the relative level of
each paired signal.
MODEL NO. M-14:2
PROFESSIONAL STEREO MIXER
ELECTRONICS