11
M-14:2
PROFESSIONAL STEREO MIXER
8. HEADPHONES OUTPUT JACK (1/4" TRS STEREO JACK)
These jacks (tip=left, ring=right, sleeve=GND) may be con-
nected to external power amplifiers for headphone
distribution, or you can plug our phones directly into the
jack. Use only stereo phones!
When a mono connector is plugged into the stereo con-
nector, it connects both sides of the headphone amplifier to a
single load. In any professional audio system, acci-dents can
happen and will have built in protection cir-cuits to assure
that momentary problems will not cause failure. However,
this circuit will fail in 2-3 minutes if this caution is not
observed.
9. POWER INDICATOR
This indicator lights when the power switch is turned on.
10. PHANTOM POWER INDICATOR
This indicator lights when the phantom power switch is
turned on.
11. OUTPUT LEVEL METER
A vertical row of ten LED show the continuous output level of
main Output L/R or monitor 1/2 by signal select switch. This
type of display is free from over shoot problem of mechanical
meters and is highly visible under poor lighting conditions.
The 0 LED means an output level of +4dB for +4dB output
(that s the rated level).
12. SOLO INDICATOR
This indicator lights when the solo switch is turned on.
13. CTRL, HEADPHONE MONITOR SELECTOR
These switches select the output signal for the Ctrl room out jack and Phones out jack.
Three push buttons to select form the following signal source : Tape in, ALT 3/4, Main mix L/R.
(1/4" Phone 3 Section Connector)
( O )
(1/4" Phone 2 Section Connector)
( X )
14
13
12
11
8
10
9
Содержание M-14:2
Страница 1: ...M 14 2 Professional Stereo Mixer PROFESSIONAL STEREO MIXER M 14 2 ELECTRONICS ELECTRONICS OC03 ...
Страница 21: ...19 M 14 2 PROFESSIONAL STEREO MIXER Applications Applications PROFESSIONAL STEREO MIXER M 14 2 ELECTRONICS ...
Страница 22: ...20 M 14 2 PROFESSIONAL STEREO MIXER Block Diagram Block Diagram ...
Страница 26: ...NOTE ...