D.A.S. M-14:2, Руководство по эксплуатации

Страница: 8 / 27

6
M-14:2
PROFESSIONAL STEREO MIXER
2. BALANCED LINE INPUT CONNECTORS
A standard 1/4" phone jack is used for balanced or unbalanced line level signals. Examples of line level
signals include most electronic keyboards, synthesizers, turn-tables(with appropriate pre-amps), tape decks
and the line outputs from other mixers. All input channel controls, including the variable GAIN control.
3. GAIN CONTROL (TRIM)
According to the level of the input signal, use this knob to adjust the input to an appropriate level. The best
balance of S/N and dynamic range will be achieved if you adjust the TRIM control so that the peak indicator
lights occasionally.
This control adjusts the channel's mic input sensitivity between -60dB and -16dB and the line input sensitivity
between -30dB and +14dB.
4. PEAK LED INDICATOR
This LED indicators let you check the level of the signal input to the channel. The peak indicator lights when
the input signal reaches 3dB below the channel s clipping point. This indicator show the level of the Post-EQ/
pre-fader signal. If the PEAK indicator lights more than briefly on high-level transients, you should use the
GAIN control to decrease the input sensitivity of the channel. If this dose not work, reduce the output level of
the connected source.
5. 3BAND EQUALIZER CONTROLS
This is a 3-band equalizer with center frequencies, range and type as shown below. The frequency response
is flat when the knob is in the "
ઓ "position.
6. AUX 1 CONTROLS
This knobs control the level of the signals sent to AUX 1 bus.
This control is placed before the channel fader, it will be not affected by the channel fader.
7. AUX 2 CONTROLS
This knobs control the level of the signals sent to AUX 2 bus. The channel signals mixed by this bus have their
overall level set by the AUX 2 SEND Control to the AUX SEND 2 jack on the rear panel. The Aux 2 bus
signal is also fed into the internal digital signal processor.
Since this control is placed after the channel fader, the signal level will be affected by the channel fader setting.
TIP(Hot)
RING(COLD)
(1/4" Phone 3 Section Connector)
SLEEVE(GND)
CONTROL
HIGH
MID
LOW
MAX. BOOST/CUT
±15dB
±12dB
±15dB
FREQUENCY
12kHz
2.5kHz
80Hz
TYPE
Shelving
Peaking
Shelving