Software Development
FM4 S6E2H-Series Starter Kit Guide, Doc. No. 002-11387 Rev. **
44
Jumper
Position
Description
J5
Open
Sets MB9AF312K (CMSIS-DAP) in run mode.
J7
Closed
Selects CMSIS-DAP as power source.
J10
Open
Sets S6E2HG in programming mode
J15
Pin1 to Pin2
Sets S6E2HG to 3.3V.
J18
Closed
Sets S6E2HG in programming mode
J19
Closed
CMSIS-DAP virtual COM connection (SIN0 to pin 21 of MB9AF312K)
J20
Pin1 to Pin2
CMSIS-DAP virtual COM connection (SOT0 to pin 20 of MB9AF312K)
J21
Pin1 to Pin2
Sets the PE0 pin to MD1 mode
3. Connect the USB cable to the CN3 port.
4. Observe that the Power LED (LED5) is glowing green.
5. Launch the FLASH MCU Programmer from Windows
Start
Menu
>
All Programs
>
Cypress
>
FLASH MCU Programmer
>
FM0+ FM3 FM4
6. Select
Target MCU
as S6E2HG6G/E/F.
7. Set Crystal Frequency to 4MHz.
8. Select the Motorola-S format file or Intel-HEX format file to be programmed to FLASH
memory in the MCU.
Note:
The HEX file selected in this example is the Test Demo firmware.
9. Check the COM Port number in the Windows Device Manager.