CY8CKIT-030 PSoC® 3 Development Kit Guide, Doc. # 001-61038 Rev. *J
30
5.
Code Examples
5.1
Introduction
To access code examples described in this section, open the PSoC Creator Start Page. For
additional code examples, visit
http://www.cypress.com
.
Figure 5-1. PSoC Creator Start Page
5.1.1
Programming the Code Examples
Follow these steps to open and program code examples:
1. In the PSoC Creator start page, go to
Examples and Kits > Kits > CY8CKIT-030 3.0
and click
on a code example.
2. Create a folder in the desired location and click
OK
.
3. The project opens in PSoC Creator and is saved to that folder.
4. Build the code example to generate the hex file.
5. To program, connect the board to a computer using the USB cable connected to port J1, as
described in
Onboard Programming Interface on page 18
. The board is detected as DVKProg.
6. Click
Debug > Program
.
7. The programming window opens up. If the silicon is not yet acquired, select the DVKProg and
click on the
Port Acquire
button.
8. After the silicon is acquired, it is shown in a tree structure below the DVKProg. Click
Connect
.
9. Click
OK
to exit the window and start programming.
10.Click the
Program
icon to program the board.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
