CY8CKIT-030 PSoC® 3 Development Kit Guide, Doc. # 001-61038 Rev. *J
12
Kit Operation
The PSoC 3 device on the board can also be programmed using a MiniProg3 (CY8CKIT-002). To
use MiniProg3 for programming, use the connector J3 on the board, as shown in
Figure 3-2
.
Note
The MiniProg3 (CY8CKIT-002) is not part of the PSoC 3 Development Kit contents. It can be
purchased from the
Cypress Online Store
.
Figure 3-2. Connect MiniProg3
With the MiniProg3, programming is similar to the onboard programmer; however, the setup
enumerates as a MiniProg3.
The Select Debug Target window may be displayed, as shown in
Figure 3-3
.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from