CY8CKIT-030 PSoC® 3 Development Kit Guide, Doc. # 001-61038 Rev. *J
11
3.
Kit Operation
The code examples in the PSoC 3 Development Kit help you develop precision analog applications
using the PSoC 3 family of devices. The board also has hooks to enable low-power measurements
for low-power application development and evaluation.
3.1
Programming PSoC 3 Device
The default programming interface for the board is a USB-based onboard programming interface. To
program the device, plug the USB cable to the programming USB connector J1, as shown in
Figure 3-1
.
Figure 3-1. Connect USB Cable to J1
When plugged in, the board enumerates as DVKProg (unconfigured). The DVKProg is configured
after opening either the PSoC Creator or PSoC Programmer application. If either of these
applications are opened before connecting the DVK to the PC, the DVKProg configuration happens
instantaneously.
After enumeration, initiate a build of the code example and program using PSoC Creator.
When using onboard programming, it is not necessary to power the board from the 12-V or 9-V DC
supply or a battery. You can use the USB power to the programming section.
If the board is already powered from another source, plugging in the programming USB does not
damage the board.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from