CY8CKIT-030 PSoC® 3 Development Kit Guide, Doc. # 001-61038 Rev. *J
20
Hardware
Figure 4-5. JTAG/SWD Programming
The JTAG/SWD programming using J3 requires the MiniProg3 programmer, which can be
purchased from
http://www.cypress.com/go/CY8CKIT-002
.
4.2.3
USB Communication
The board has a USB communications interface that uses the connector, as shown in
Figure 4-6
.
The USB connector connects to the D+ and D– lines on the PSoC to enable development of USB
applications using the board. This USB interface can also supply power to the board, as discussed in
Power Supply on page 15
.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from