CYP DS-VWC2-4K22, Руководство по эксплуатации

Страница: 46 / 100

40
6.5.8 Warping Mode Layouts
The position, size and angle of the display connected to each unit is
set in the Layout window’s Warping tab when in Warping Mode. If you
are currently in the Setting window, clicking on the “Layout” button in
the upper-left “Common” section of the window will switch back to the
Layout screen. If the unit is not currently in Warping mode, clicking on the
“Warping Mode” button on the upper right side of the Layout window
will force the unit to change modes. The warping effect can be manually
turned on and off using the “Warping On/Off” buttons in the bottom left
section of the Warping tab.
Note: The unit must be in Warping mode for this tab to be populated and
controllable.
The outline of the warping layout window represents the source video at
a resolution of 3840×2160 pixels and each display should be positioned
within this space. It is possible for a display to extend beyond the edge
of the source, if desired, but the area outside the source’s boundary will
be filled with black. Each display contains a number which matches the
ID number of the unit that is connected to it and the size/position of
each display (listed to the left) is measured in pixels relative to its size/
position within the layout space. Pre-defined layouts do not include bezel
compensation.
Note: The pixel size of individual displays MUST be between 1536×864 and
3840×2160. Display sizes set outside this range will automatically be adjusted
when the “Set” button is pressed.