CYP DS-VWC2-4K22, Руководство по эксплуатации

Страница: 35 / 100

29
remove both real and dummy units from a layout, select the unit to
remove and then click the “−” button.
5) Binding: To change the unit assigned to display, right click on the
display’s number and select “Binding”. This will open up a window
where you can select a new unit to assign to the display.
6.5.3 Basic Unit Settings & Configuration
The basic configuration and settings for each connected unit can be
set by selecting the unit to configure from the “Units” section and then
clicking on the “Setting” button in the upper-left “Common” section of
the window. The operational mode of the unit (Warping mode or Scaling
mode) may be set here, as well as the Ethernet, I/O, and mode-specific
image features. To exit the setting configuration tabs and return to the
layout mode, click on the “Layout” button in the upper-left “Common”
section of the window.
Note: Some configuration options are not available in both modes.
The “General” tab provides control over the network configuration, and
provides a way to initiate a firmware update or perform a factory reset.
This tab provides the same options in both operational modes.
1) System Setup: Displays the current firmware version and provides
options to update the firmware or perform a factory reset on the unit.
„
Update FW Button: Provides a way to update the unit’s firmware.
Insert a USB thumb drive, with a valid firmware file (*.bin format)
in the root directory, into the unit’s USB service port then click the
“Update FW” button. After the update is complete the unit will