CHECK YOUR WORK
• HOLD Child Restraint at each side near Rear-Facing Belt Paths. Pull side to side
and forward. Child Restraint should not move more than 1 in. (2.5 cm) from vehicle
seat back or side-to-side.
• Make sure Child Restraint is level for rear-facing use (p. 31-32). Make sure
child's head does not fall forward. If necessary, loosen the vehicle belt, readjust
recline and repeat installation steps to make sure Child Restraint is installed properly.
• Check installation before every use.
The Lock-Off is for lap/shoulder belt systems only and is not needed for lap belt only
installation.
1. Route vehicle lap belt through the blue Rear-Facing Belt Path on the side of the
Child Restraint.
2. Route the vehicle lap belt under the Seat Cover.
For Infant and Toddler use, route the vehicle lap belt in front of the Crotch Strap
a
.
For Child use, route the vehicle lap belt behind the Crotch Strap
b
.
Note:
See page 28 for proper Crotch Strap adjustment. The Crotch Strap should
ALWAYS be as close as possible to, but NEVER under, the child's bottom.
3. Pull vehicle lap belt down through the blue Rear-Facing Belt Path on opposite side
of the Child Restraint. Buckle the vehicle belt.
4. While pushing down on the Child Restraint
c
, pull the loose end of the vehicle belt
d
to tighten the belt.
40
39
1
2 3 4 5 6 7 8 9
10
10 9 8 7 6 5 4 3 2 1
1
2
10 9 8 7 6 5 4 3 2 1
c
d
4
CLICK!
AR
M
PIT
LE
VE
L
AR
M
PIT
LE
VE
L
a
b
3
INSTALL REAR-FACING USING LAP BELT ONLY
INSTALL REAR-FACING USING LAP BELT ONLY
EN
REAR-F
ACING
