• Check installation
before every use.
CHECK YOUR WORK
• HOLD Child Restraint at each side near Forward-Facing Belt Paths. Pull side to
side and forward. Child Restraint should not move more than 1 in. (2.5 cm) from
vehicle seat back or side-to-side.
• Make sure ball is between lines on label for forward-facing use (p. 41-42).
If necessary, loosen the vehicle belt and Tether, readjust recline and repeat
installation steps to make sure Child Restraint is installed properly.
4. While pushing down on the Child Restraint
a
, pull the vehicle shoulder belt
b
to
tighten the vehicle lap belt.
5. Continue to pull on the vehicle shoulder belt and position the shoulder belt in the
middle of the Lock-Off area. Lock-Off will not function properly if the vehicle belt
is not positioned properly. Reattach Seat Cover.
6. Locate Tether anchor in your vehicle. Attach Tether Hook. Pull Tether Adjuster
Strap to tighten.
The Lock-Off provides a way to lock the Child Restraint without needing to lock
your vehicle seat belt.
1. Remove Tether from Tether Compartment. Route vehicle lap/shoulder belt
through the red Forward-Facing Belt Path on the side of the Child Restraint.
Lift the padding on the back of the seat and pull the vehicle belt through the
opening on the opposite side of the Child Restraint.
2. Pass the vehicle belt along the back of the Child Restraint as shown.
3. Pull vehicle belt down through the red Forward-Facing Belt Path on the opposite
side of the Child Restraint. Buckle the vehicle belt.
Note:
Before tightening the vehicle belt, route the shoulder belt through the
Lock-Off.
48
47
10 9 8 7 6
5 4
3 2
1
10 9 8 7 6
5 4
3 2
1
1
5
6
1
2 3
4 5 6 7 8 9 10
2
3
4
a
b
CLICK!
CLICK!
10 9 8 7 6
5 4
3 2
1
6 5
4 3
2 1
Place belt here.
INSTALL FORWARD-FACING USING LAP/SHOULDER BELT
INSTALL FORWARD-FACING USING LAP/SHOULDER BELT
EN
FOR
W
ARD-F
ACING