17
Step 1. Use a slotted screwdriver to gently lift out the LCD panel.
Step 2. Disconnect the cable connector.
Step 1. Receptacle evaluation
Ensure that the plug type of your ATS PDU unit matches the
receptacles that you are using.
Electrical Installation
The ATS PDU must be plugged into a three-wire, grounded utility receptacle or
a UPS that is connected to a grounded utility receptacle. The utility receptacle
must also be connected to an appropriate branch circuit/main with fuse or
circuit breaker protection. Connection to any other type of receptacle may
result in an electrocution hazard.
Step 2. Plug the ATS PDU into the utility receptacle and/or UPS.
For configuration details, refer to ATS PDU Configuration on page 8.
Step 3. Attach equipment
It is extremely important not to exceed the ATS PDU's maximum
current load (as outlined in the Specifications section). In order to
determine total load, use the LCD screen on the front of the ATS
PDU to monitor the load being attached.
Installation Guide
Replacing the LCD Panel