CXR CIP-2ALL, Руководство пользователя

Страница: 22 / 54

User manual CIP-ALL
CIP-ALL - Page 22
Channel assignment:

Assigns one or several analog ports to the Bundle. The remote equipment must be set accordingly.
Number of frames:

The analog interface is sampled very 125 µS to generate a 64 kbps stream. This parameter defines how many such 125 µS samples are
transported into an Ethernet packet. The higher number of samples the higher end to end latency, but the lower required bandwidth on the
Ethernet network. This number is limited to 4, 8, 16 frames if the CAS signaling standard is selected, otherwise between 4 and 1500.
PSN type:

Choose a protocol packet header to transport the packet over an IP or a MEF Ethernet network. Note that the MEF protocol is not routable.
IP DSCP (used in UDP/IP):

Differentiated Service Code Point: any value may be defined from 0 to 63 for the QOS traffic classification.
IP TTL (used in UDP/IP):

Time to Live value for the transmitted IP packet : 128 as default value
Number of VLAN tags:

Define if a VLAN tag is use, and 1 or 2 tags are inserted : No, 802.1Q (single VLAN tag), stacked VLAN, 802.1ad and Q-in-Q (2x VLAN
tags)
802.1Q frame:
DA, SA, 0x8100, VID1
802.1ad frame, Q-in-Q :
DA, SA, Tag VLAN provider Tag (0x8100, 0x88A8, 0x9100), VID1, 0x8100, VID2
VLAN ID 1, Priority VLAN ID 1:

VLAN identifier: 0 to 4095, and priority bits from 0 to 7.
VLAN ID 2, Priority VLAN ID 2:

VLAN identifier: 0 to 4095, and priority bits from 0 to 7.
Then set the Bundle to On or Off, and “save” the Bundle configuration for later use, or “Apply” to save and run immediately the
Bundle. On-going transmissions may be interrupted or modified by these new parameters.
It is possible to make two bundles with different parameters and to activate only one at a time to two identical connections.
See the status of Bundle error states if the configurations are inconsistent: e.g. “Apply” 2 Bundle on the same links at the same time.
Packets Information:

By clicking on the Update button it allows to know the Bandwidth used by the channel.

Don’t forget that the Bundle has two senses and the Bandwidth used is doubled.

A Bundle created with an analog port in the proprietary mode will be more efficient than the CAS transport mode.