10
11
Step 3
: Place the master finger on the glass of the sensor to verify (LED
displays “F0-no”)
Step 4
: Press “01” and “#” button (LED displays “id”)
Step 5
: Enter ID number with 2 digits between 01 and 09 and press “#” button
or just press “#” button
The fingerprint sensor will then turn on with a red light and LED
displays ID number you just entered (in case of entering ID + “#”) or
next available(empty) ID number (in case of pressing “#” only)
Please record the ID number and the details for each fingerprint
enrolled. The correct ID number will be needed when deleting an
individual fingerprint (Refer to 2.1.2 for deletions)
Step 6
: Place chosen sub-master finger on the glass of the fingerprint sensor
twice while the fingerprint sensor turns on and off.
(if you do not complete Step 4 above within 5 seconds, the mode will be
changed to main control mode and LED displays “no”).
“no” in LED means the lock is waiting for entry of function codes (for example :
“01” for sub-master or user enrolment) for further programming. (refer to 3.1 for
programming code table)
You can exit from programming mode by pulling down the sliding cover in the
front body.
2.1.2 How to enroll sub-master fingers (ID Number 01 through 09)
After successful master fingerprint enrollment, you can enroll sub-master
fingerprints up to 9 fingers with assigned ID number at 01 through 09. Each
sub-master fingerprint can also be used to verify for all the enrollment/deletion
of the fingerprints/User Access Codes (PIN Codes) and change of data/setting
exactly same as master fingerprint. We recommend that you enroll several
sub-master fingers from each hand in case you have difficulty having your
master finger verified by the lock (due to an injury to the master finger, for
instance)
Step 1
: Open battery cover and press the “F” button in the back body of the lock
Step 2
: Pull up the sliding cover in front body of the lock
(The fingerprint sensor will then turn on with a red light)
Enter ID number (e.g. : “02”) and “#”